The WEMA Joker 8000 CNC is a further development of our tried-and tested WEMA Joker 7000 CNC. The turning support and the longitudinal slides run on hardenend and ground law-maintance ball trans- fer guides, on which the tailstock is guided extra precisely. This is very advantageous when turning large parts like columns. The lathe chisel is located very close to the revolving collar plate which guarantees vibration-free turning of the workpiece profile. Collar plates and accessory parts can be retrofitted at any time.

The standard design of the machine is equipped with 3 programmable axis: two feed axis and one rotational axis for milling. The WEMA Joker 8000 CNC can also be delivered as 4 axis machine with 2 turning axis.
   
All profiles can be designed using MEGA CAD transferred to the machine via interfaces. The machine can work unhindered during programming periods. A large momory area (32 MB) allows storage of approximately 2000 programs. One PC is sufficient for severals machines.
   
The drive unit for the supports is fitted to the rear of the machine to provide plenty of space on the operating side. The operating and control elements are both coordinated on a travelling control panel without disturbances. All control and electronic components are located on the machine tool table. A separate electrical-control cabinet is therefore not required. The infinitely variable drives allow quick
adjustment to optimum cutting conditions, thereby garanteeing optimum turning and milling quality. The machine can be quickly refitted from turning to milling by means of a quick-change system.
   
The particularly heavy cast iron base is completely rigid and torsion-free.

Standard design 1600 mm, 1950 mm, 3100 mm and 4100 mm.
360 mm, maximum turning diameter via support: 480 mm.
Infinitely variable. Quick return motion with main limit switch.
M45, collar 46 mm, inner cone MT 3. Hollow spindle with 14 mm bore diameter, with reinforced
triple bearing by means of precision angular ball bearing.
Eccentric quick gripping and safety lathe base gripping, sleeve MT 3, sleeve lift 150 mm. With adjustable articulated quick-action lever, upon request.
Ring collar plate for 15-75 mm / 80-130 mm diameters with quickly interchangeable insertion rings. Four jaw collar plates infinitely adjustable for diameters from 30-60 mm, 60-100 mm,100-140 mm and 140-180 mm.
Transmittion device. 4,0 kW rotary current infinitely variable speed within two ranges: 150-1500 or 400-4000 RPM.
Two feed axes and one rotational axis (spindle) Driven via maintenance-free AC-servomotors.
400/230 V, 3 P/N/PE, 50/60 cyc. Special voltage upon request.
For ring collar plates and support: 100 mm diameter respectively.
Motor 3.0 KW, infinitely variable speed from 6000-18000 RPM. Collet chuck attachment up to 16 mm in diameter. Adjustable height and swivelling in two directions up to 90° .